Mild Steel Sliding Gate 004

Mild Steel Sliding Gate:

Sliding Gates are very reliable and have long trouble-free lifespans. Mild Steel sliding gates with optional HPL, WPC, and Fiber sheet Occupy less Space as compared to swing gates. It maximizes space on the drive because the gate opens sideways rather than inwards. Preference for industrial, Commercial, and residential applications.

How do you install a Sliding gate Track?

Cut out and remove about a 150mm wide strip. Level the area with stone and compress. The Sliding Gate Lay the floor track in the trench and use the joining pins to join the lengths together. Level with a straight long edge and spirit level while aiming to keep the bubble of the level within the lines. On a loose substrate hammer small pins to either side of the track every 450mm. When it becomes tight weld it to the rack and cut off the excess. Lastly using Concrete, Backfill the top 13 ∼ 15 mm of the 20mm bar that’s Showing.

Troubleshooting Procedure for Mild Steel Sliding Gates:

Troubleshooting the Automatic Mild Steel Sliding Gates if the lock hangs up and does not latch properly try the following steps before contacting technical support

• Reset the closed position limit so the gate is snug against the stop plate.
• Lubricate the latch with silicone spray to help the latch to operate freely.
• Check the alignment of the lock by using the key to hold the latch open while operating the gate opener.

The Edge of the ground track should be in line with the post Fix in place and then install the extension. Place the gate on the ground track with the midpoint in line with the post on the receiving.

Featured Product:

What are the advantages of Automatic Mild Steel Sliding Gates?

• Planned and fabricated with superior square or rectangular hollow sections, along with MS sheets and flats collected by high-quality welding.
• Manual operation in case of power failure.
• Highly condensed dimensions & very silent operation. Built-in anti-jerk device stops damage to the automatic system
• Problem detection causes the gate movement to stop if a hindrance or person is detected
• The advance electronic control unit licenses operation time adjustment, partial opening, reflex closing, step-by-step control, stop safety, reverse safety etc.